🔮How to use BribeAI assistance

This section explains how to use BribeAI assistance

To check what might be the most efficient bribe of a launch that you would like to snipe send the command “/assist” to the BribeAI Bot

Bot will ask you for the Ethereum CA you want to check, paste the CA you would like to snipe

Provide the ETH address you want to snipe

After this step, the bot will ask you how many snipers you are seeing in Banana Bot.

In order to get this information, open Banana Bot, paste the CA that you want to snipe and set-up a snipe with very low max spend and max tip (e.g. 0.001).

After the snipe is set-up you can see how many snipers are already trying to snipe the launch with Banana.

How many snipers are trying to snipe the next launch

Now cancel your snipe in Banana

Cancelling a snipe in Bananabot

Go back to BribeAI Bot and click on the relevant button

Click on the button corresponding to Banana snipers

Now the bot will read onchain for how many wallets have already pre-approved the contract.

Preapprovers

At the same time the bot will run an off-chain simulation to check important sniping information such as MaxTx, MaxWallet and Taxes.

Pre-launch tax simulation

BribeAI Bot has now all the information needed to compute the estimated most efficient bribe and it will print out the BribeAssistance

If the pre-launch tax simulation has been successful, the next max-bag will also be used to compute the estimated efficient bribe - otherwise only the other parameters will be used.

BribeAssistance Report - including max net bag

BribeAssistance Report - without max net bag

The report summarizes the most important information of the CA that you are trying to snipe and provides you with the estimated efficient bribe to use as a starting point for your bribe estimate.

📣 Important 📣

Run the BribeAssistance report close to the actual launch of the token that you want to snipe.

This is because:

  1. Many snipers set-up their snipe very close to the launch, therefore the information in Banana Bot on how many wallets are ready to snipe can change.

  2. Same applies for the pre-approvers on-chain, many pre-approves the CA minutes before the launch.

  3. AI takes in consideration the hour of launch and current gwei to provide an estimated bribe. If you run the report hours before, these values will be different.

Last updated